1. Log into the management page (see “Access your management page” on page 7).
2. Click on Wireless, and click on Wi-Fi Protected Setup.
3. To add a wireless device to your network, next to Client, enter the 8-digit numeric PIN
number of the wireless client device and click Start PIN. Note: You may need to initiate
the WPS PIN on your wireless device first when using this method. Refer to your wireless
device documentation for details on the operation of WPS.
4. Wait for your router to finsh the WPS process.
Note: You should a message on your WPS client device indicating WPS was successful.
Change your access point IP address
Setup > LAN Settings
Typically, the access point IP address settings only needs to be changed when
connecting the access point to your network and configuring to the device to be in the
same IP network as your existing network.
Default Access Point IP Address Settings: 192.168.10.100 / 255.255.255.0
1. Log into the management page (see “Access your management page” on page 7).
2. Click on Main, and click on Network Settings.
3. Under Connection Type, click the drop-down list to select the access point IP address
settings.
IP Address: Enter the new access point IP address. (e.g. 192.168.0.100)
Subnet Mask: Enter the new access point subnet mask. (e.g. 255.255.255.0)
4. To save changes, click Apply.
Note: You will need to access your access point management page using your new
access point IP address. (e.g. Instead of using the default http://192.168.10.100 your
new access point IP address will use the following format using your new IP address
http://(new.ipaddress.here) to access your access point management page. You can
also use the default login URL http://tew-817dtr
Your access point can be used as a DHCP (Dynamic Host Configuration Protocol) server
to automatically assign an IP address to each wireless device connected. The DHCP
server settings can be accessed when access point is set to Static IP address and it is
disabled by default
To Next Page
Loading...
