Triumph Trophy - Triumph Electronic Suspension (TES) Warning Light (if Electronic Suspension Is Fitted)

31
General Information
Triumph Electronic Suspension (TES)
Warning Light (if electronic
suspension is fitted)
Triumph Electronic Suspension is
fitted to Trophy SE models only.
When the ignition is switched on
the warning light will illuminate
for 1.5 seconds and then go out.
1. TES warning light
2. Instrument message
The warning light has three modes:
• Adjustment (see page 58) - the
warning light will flash once per second,
and the lower message screen will
display the alternating messages PLEASE
WAIT and ADJUSTMENT IN
PROGRESS. Once adjustment is
complete the message ADJUSTMENT
COMPLETE will be displayed for a short
time.
• Calibration (see page 57) - the warning
light will flash twice every second during
system recalibration, and the lower
message screen will display the
alternating messages PLEASE WAIT and
RECALIBRATION IN PROGRESS.
During recalibration the motorcycle must
remain stationary. Riding the motorcycle
will cause the recalibration to be halted
and the warning light to remain lit.
• Fault - If the warning light illuminates
continuously or at any other time it
indicates a fault with the system that
requires investigation.
Full details of the Triumph Electronic
Suspension (TES) system are described
starting on page 58.
TRIP 1
MPH
0
10:08
N
26°C
1892
ODO
144.2
TES SYSTEM
ADJUSTMENT
IN PROGRESS
1
2
chdo