Triumph Trophy - Right Handlebar Switches; Engine Stop Switch; Starter Button; Cruise Control ON;OFF Button

65
General Information
Right Handlebar Switches
1. Engine stop switch
2. Starter button
3. Cruise control adjust button
4. Cruise control ON/OFF button
Engine Stop Switch
In addition to the ignition switch being turned
to the ON position, the engine stop switch
must be in the RUN position for the
motorcycle to operate.
The engine stop switch is for emergency use.
If an emergency arises which requires the
engine to be stopped, move the engine stop
switch to the STOP position.
Note:
• Although the engine stop switch
stops the engine, it does not turn off
all the electrical circuits and may
cause difficulty in restarting the
engine due to a discharged battery.
Ordinarily, only the ignition switch
should be used to stop the engine.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the clutch
lever must be pulled to the handlebar.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down and
a gear is engaged.
Cruise Control ON/OFF Button
When the cruise control button is pressed in,
the cruise control is on (see page 59). The
button will remain in until it is pressed again
to turn off the cruise control.
Cruise Control Adjust Button
The cruise control adjust button is a two way
switch with the top marked RES/+ and the
bottom marked SET/- (see page 59).
4
2
3
1
chdc
Caution
Do not leave the ignition switch in the
ON position unless the engine is running
as this may cause damage to electrical
components and will discharge the battery.