95
General Information
Breaking-in
Breaking-in is the name given to the process
that occurs during the first hours of a new
vehicle's operation.
In particular, internal friction in the engine will
be higher when components are new. Later
on, when continued operation of the engine
has ensured that the components have
'bedded in', this internal friction will be
greatly reduced.
A period of careful breaking-in will ensure
lower exhaust emissions, and will optimize
performance, fuel economy and longevity of
the engine and other motorcycle
components.
During the first 500 miles (800 kilometers):
• Do not use full throttle.
• Avoid high engine speeds at all times.
• Avoid riding at one constant engine
speed, whether fast or slow, for a long
period of time.
• Avoid aggressive starts, stops, and rapid
accelerations, except in an emergency.
• Do not ride at speeds greater than 3/4 of
maximum engine speed.
From 500 to 1000 miles (800 to
1500 kilometers):
• Engine speed can gradually be increased
up to the maximum engine speed
(red zone) for short periods.
Both during and after breaking-in has been
completed:
• Do not over-rev the engine when cold.
• Do not lug the engine. Always downshift
before the engine begins to 'struggle'.
• Do not ride with engine speeds
unnecessarily high. Shifting up a gear
helps reduce fuel consumption, reduces
noise and helps to protect the
environment.
To Next Page
Loading...
