60
General Information
To activate cruise control, the following
conditions have to be met:
• The motorcycle is travelling at a speed
between 30 to 100 mph (48 to 160 km/h);
• The motorcycle is in 4
th
gear or higher;
• The SET/- on the adjust button is
pressed.
The cruise control light will illuminate
indicating that cruise control is active and set,
and the set speed will be displayed in the
lower display area of the multi-function
display. The current set speed will be stored
until the ignition is turned off, and can be
resumed by pressing and releasing the RES/+
end of the adjust button (see page 62).
1. Cruise control warning light
2. Set speed
Note:
• Riding with either brake actuated or
the clutch not fully released will
prevent operation of the cruise
control system.
Deactivating Cruise Control
The cruise control can be deactivated by one
of the following methods:
• Roll the throttle fully forward;
• Pull the clutch lever;
• Operate the front or rear brake;
• Increase speed by using the throttle for
more than 60 seconds;
• Press and release the on/off button on
the right hand switch cube.
Provided the cruise control has not been
deactivated by turning the ignition switch to
the OFF position, the previous set speed can
be resumed by pressing and releasing the
RES/+ end of the adjust button. The
motorcycle speed has to be between
30to100mph (48to160km/h) and in
4
th
gear or higher.
To Next Page
Loading...
