52
General Information
Units of Measure (Imperial,
US or Metric)
UNITS has two selectable display modes,
MILE and KM. If mile is selected it is possible
to customize the display to show units in:
• MPG (UK) - the fuel consumption will be
measured in imperial gallons;
• MPG (US) - the fuel consumption will be
measured in US gallons;
• temperature - °C or °F;
• pressure - PSI or BAR.
If km is selected it is possible to customize the
display to show units in:
• L/100 KM - the fuel consumption will be
measured in liters of fuel per 100 km
(62 miles);
• KM/L - the fuel consumption will be
measured in kilometers per liter of fuel;
• temperature - the default temperature
for metric units is °C;
• pressure - PSI or BAR.
To access the units display; see BIKE SETUP
on page 49.
Tire Pressure Monitoring
System (TPMS) (if equipped)
Note:
• The Tire Pressure Monitoring
System (TPMS) is standard
equipment on Trophy SE models,
and available as an accessory on
Trophy models. On Trophy models
TPMS must only be fitted by your
authorized Triumph dealer. The
TPMS display will then be activated
by your authorized Triumph dealer.
The daily check of tire pressures must not
be excluded because of the mounting of
the TPMS. Check the tire pressure when
the tires are cold and using an accurate tire
pressure gauge (see page 14 4 ).
Use of the TPMS system to set inflation
pressures may lead to incorrect tire
pressures leading to loss of motorcycle
control and an accident.
To Next Page
Loading...
