Triumph Trophy - Page 57

57
General Information
Once a mode or loading adjustment has
been selected, and the engine is running, the
suspension will start to adjust, the TES
warning light will flash once every second
and the lower message area will display the
message PLEASE WAIT - TES SYSTEM
ADJUSTMENT IN PROGRESS, until the
system has finished adjusting.
TES Adjustment in Progress
Once adjustment is complete the message
TES SYSTEM ADJUSTMENT COMPLETE
will be displayed and the warning light will go
out.
Adjustment Complete
If the engine is not running when a profile is
loaded, or the ADJUSTMENT menu is used
to change the MODE or LOADING settings,
the request to change the settings will be
saved.
Once the engine has started, the adjustment
will be made as described above.
If the engine is not started before the ignition
is switched off then the requested setting will
be lost and the previous settings will be used.
It is also possible to store the TES settings to
two separate profiles (see page 47), allowing
settings to be stored for different rider’s
individual preferences, different riding styles
or different loading conditions.
System Calibration
The system will re-calibrate the damper
adjustment motors each time the ignition is
turned on
and the pre-load adjustment
motor after every 50 ignition on cycles, once
the engine is started.
Damper adjustment motor calibration takes
approximately 2 - 3 seconds, and pre-load
motor calibration takes around
20 - 30 seconds.
TRIP 1
MPH
0
10:08
N
26°C
1892
ODO
144.2
TES SYSTEM
ADJUSTMENT
IN PROGRESS
chdo
TRIP 1
MPH
0
10:08
N
26°C
1892
ODO
144.2
chdo
TES SYSTEM
ADJUSTMENT
COMPLETE