Trocen AWC608C - Page 3

LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
2
3.13.5 Unite Lines................................................................................................................................ 42
3.13.6 Image Invert.............................................................................................................................. 42
3.13.7 Image Dither............................................................................................................................. 42
3.13.8 Parallel Offset .......................................................................................................................... 43
3.13.9 Estimate Work Time............................................................................................................... 44
3.13.10 Simulate .................................................................................................................................. 44
3.14 Default Parameters............................................................................................................................... 44
Chapter 4 Laser Machining .............................................................................................................................. 45
4.1 Position Relative...................................................................................................................................... 45
4.2 Array Output Options ............................................................................................................................ 46
4.3 Layer Options.......................................................................................................................................... 47
4.3.1 Set Layer Parameters ............................................................................................................ 48
4.3.2 Adjust Layer Working Sequence ........................................................................................ 51
4.4 Machine Control...................................................................................................................................... 51
4.4.1 Download image data& machine documents management .......................................... 51
4.4.2 Machine Control ........................................................................................................................ 54
Chapter 5 CorelDraw Based Software........................................................................................................ 55
5.1 Manual Download Tool“AWCLaserCut”.............................................................................................. 55
5.2 Display hidden tool “AWCLaserCut”.............................................................................................. 57
5.3 Import DST/DSB file............................................................................................................................. 57
5.4 Switch CorelDraw to LaserCAD ....................................................................................................... 58
Chapter 6 AutoCAD Based Software .......................................................................................................... 59
6.1 ADD AWCLaserCut toolbar................................................................................................................... 59
6.2 Switch AutoCAD to LaserCAD.......................................................................................................... 60
Chapter 7 Introduction Manual of blue LCD Panel .................................................................................... 62
7.1 Function introduction to each key......................................................................................................... 62
7.2 Interface of starting computer............................................................................................................... 63
7.3 Function introduction to main interface............................................................................................... 64
7.3.1 Check and Alter the properties of current file................................................................... 65
7.3.2 Clear total working times of file (refer to view 7-3).......................................................... 66
7.3.3 Switch between “Power 1”&“Power 2” (refer to view 7-3)............................................. 67
7.3.4 Change speed, Maximum power, Minimum power (refer to view 7-3)........................ 68
7.4 Main menu function................................................................................................................................ 68
7.4.1 UDisk file..................................................................................................................................... 69
7.4.2 Parameter Option...................................................................................................................... 71
7.4.3 Origin manage ......................................................................................................................... 71
7.4.4 Origin Mode................................................................................................................................ 72
7.4.5 Control Mode.............................................................................................................................. 73
7.4.6 Memory management .............................................................................................................. 74
7.4.7 Axes Control .............................................................................................................................. 74
7.4.8 Inching control .......................................................................................................................... 75
7.4.9 Cut box ........................................................................................................................................ 76
7.4.10 Network Config........................................................................................................................ 76
7.4.11 Languages................................................................................................................................ 77
7.4.12 System Version....................................................................................................................... 77