Trocen AWC608C - Chapter 5: CorelDraw Integration; AWCLaserCut Tool Setup

LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
55
Chapter 5 CorelDraw Based Software
5.1 Manual Download Tool“AWCLaserCut”
After installation of CorelDraw direct output, (refer to Chapter 2 Installation of Software）,start
CorelDraw, Main interface of CorelDraw12 shown as below:
（1） Click menu【Tool】/【Macro】/【Run Macro】 as follows:
（2） Dialog displayed as follows: