Trocen AWC608C - 2 Origin Manage

LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
88
press
, system will upgrade according to upgrade file. System will go to state of reset after
upgrade finished. During update, don’t cut power of control panel. Otherwise it will damage the system.
(suffix of system upgrade file is ug5)。
8.4.1.4 Save Current parameter to UDisk(refer to graphic 8-4-1)
Under【UDisk file】interface, press
or to move cursor onto item【Curr config to UDisk】.
Press
, system will copy a parameter of control panel into U-disk. The file name is Params.cf5。
8.4.2Origin manage (Refer to view 8-4)
Under the main menu interface, press
or or to move cursor onto item 【Origin
manage】, then press
to enter into【Origin manage】interface:
view8-4-2-1
Press
or to move cursor onto one item, and then press :
Move cursor onto item【move to origin1】, and then press
, system will move laser head to the
original position 1 (X=0.0mm，Y=0.0mm).
view8-4-2-2
Move cursor onto item [Current as Origin1], and then press
, system will set the position of