Trocen AWC608C - Function Introduction to Main Interface

LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
64
power (In-process power), the number behind is minimum power(power when turn
around)
【power 1】can be switched to【power 2】 shown as below:
【speed】：Speed value set during machining graphic
【X】：show X-axis value of laser head with machine
【Y】：show Y-axis value of laser head with machine
7.3 Function introduction to main interface
View 7-3
Under the main interface, press
, cursor will appear on one item selected show as below:
When there is no cursor, system is in state of “Key moving“; when there is cursor, system is in state of
“parameter alteration”.
In the state of “Key moving“:
(1) press
, cursor will appear and system will enter into state of “parameter alteration”；