Trocen AWC608C - Z;U Axis and File System

LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
78
Version of 【Main Board】can be upgraded by【UDisk file】to the newest one. （Refer to 7.4.1.3
System upgrade file）
7.5 Z/U axis
Under the main interface, press :
Press
or to move cursor to select one item
When select【Auto focus】and press
, Z-axis will move at the speed of 【Z-axis reset speed】
(Refer to: 3.3.3.2), stop till touch Z+ limit switch, and then move the distance as in【Focus distance】in
opposite direction.(Refer to: 7.4.2)
When select【ZU move】,and press
or , Z-axis starts to move, release or , Z-axis
stops moving.
Press
or , U-axis starts to move, release or , U-axis stops moving.
7.6 Files system
Under the main interface, press to enter into 【file】interface: