LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
79
In【file】interface, it will show all working files saved in the memory of control board.
Press
or or or to move cursor on one item and then press
Press or to move cursor to select one item
Select【select】, and press
, system will select files and go back to main interface. In main
interface, the file sequence number will be shown in【file】; Press
in main interface will
start files output.
Select【delete】, and press
, then files will be deleted.
Select【copy to UDisk】, and press
, then files will be copied to UDisk（UDisk only support
FAT32）
To Next Page
