AWC7813 motion controller user manual
Click 【Axis Movement】, and click the front button of 【Jog Distance】,
select "√", then click the value button after 【Jog Distance】, enter the
value you need to move, and click the left or right moving button to
measure the actual movement the distance. If the actual moving distance is
the same as the jog distance, the distance per pulse is correct, otherwise
repeat 3-6 actions.
3.16.1.2 Valid Pulse Edge
【Valid Pulse Edge】 refers to the effective value of the driver level change. The
user can set it to 【Rising edge】 or 【Falling edge】 as required. If the setting is
wrong, there will be a misalignment phenomenon, that is, when returning to the
positioning point at the end of each repeated cutting, it will shift in one direction and
when cutting a large figure, the figure will shift in one direction.
3.16.1.3 Datum Direction
【 Datum Direction 】 refers to the direction in which the motion axis moves
when the machine is reset. When the setting is wrong, the axis will reset in the
opposite direction.
When you click the 【Reset】 button, or click 【More】→【Reset】→【X&Y
Reset 】 , the laser head does not move in the direction of the origin, but in the
opposite direction, the 【Datum Direction】 needs to be modified.
Note: It may need to modify a certain axis parameter of X, Y axis or both X and Y
axis parameters, depending on the actual situation.
3.16.1.4 Key Direction
【 Key Direction 】 refers to the direction in which the axis moves when the
arrow keys are pressed on the panel. If the setting is wrong, when you press the
To Next Page
Loading...
Need help?
General
