Trocen AWC78 Series User Manual

AWC7813 motion controller user manual
WWW.SZTROCEN.COM
7
3.14.2 Example analysis
................................................................................
51
3.14.2.1 Wavy lines appear when cutting arcs
.....................................
51
3.14.2.2 Wavy lines appear at the beginning and corners of the cutting52
3.15 Common Parameters Settings
......................................................................
52
3.15.1 Work Mode
........................................................................................
52
3.15.1.1 Go Origin After Reset
.............................................................
53
3.15.1.2 Origin Mode
...........................................................................
53
3.15.1.3 Go Back Position
.....................................................................
54
3.15.1.4 Count Mode
............................................................................
54
3.15.2 Common Parameters
.........................................................................
54
3.15.2.1 AutoFocus Distance(mm)
.......................................................
55
3.15.2.2 KeyMove’Speed(mm/s)
..........................................................
55
3.15.2.3 RunBox’Speed(mm/s)
.............................................................
55
3.15.2.4 CutBox’Speed(mm/s)
.............................................................
56
3.15.2.5 Blow Open Delay(s)
................................................................
56
3.15.2.6 Blow Close Delay(s)
................................................................
56
3.15.3 Axis Speed Parameters
......................................................................
56
3.15.3.1 Z Work Speed(mm/s)
..............................................................
57
3.15.3.2 XY Home Speed(mm/s)
..........................................................
57
3.15.3.3 Z Home Speed(mm/s)
............................................................
57
3.15.4 Rotate Engraving & Cutting
...............................................................
58
3.16 Manufacturer Parameters Settings
..............................................................
61
3.16.1 Axis Parameters(take X axis as an example)
......................................
61
3.16.1.1 Distance Per Pulse(um)
..........................................................
62
3.16.1.2 Valid Pulse Edge
......................................................................
65
3.16.1.3 Datum Direction
.....................................................................
65
3.16.1.4 Key Direction
..........................................................................
65
3.16.1.5 Limit-Switch Valid Level
..........................................................
66

Trocen AWC78 Series Specifications

General

Brand	Trocen
Model	AWC78 Series
Category	Security Sensors
Language	English