NORMAL.DOT Gespeichert in:G:\Support\Dokumentationen_CDs\8003Speedy\Service Manual\Servicemanual 8003.doc Gespeichert am:2003/03/10
max Version 14
Seite 58 von 87
I N D I V I D U A L M A R K I N G S Y S
12. Replace the main belt
- Connect the new belt to the old one. Pull out the old belt (and at the same
time pull in the new belt)
13. Replace the ball bearings, the Y-gearing assembly and the motor belt
There are ball bearings on the front and on the back of the Y axis.
One each on the upper and lower end of the Y-gearing assembly and two on
the main belt idler pulley.
- Take out the gearing assembly (including ball bearings) and the motor belt
and replace it.
replace gearing assembly
- Take out the idler pulley, remove the old ball bearings and replace them for
new ones.
tensioning
wedge
tensioning
bolt
gearing
assembly
To Next Page
Loading...
Need help?
General
