Troxler 3440 - Page 50

4–4
STORING A READING
The 3440 gauge allows the operator to store measurements under specific
project numbers and station numbers for later recall. This function will
work in soil mode as well as in asphalt mode. The 3440 will provide for
additional numeric data storage under the station number and project. The
operator can also setup the gauge to prompt for the information required on
U.S. Federal Highway Administration (FHWA) projects (see page 6–31).
The 3440 gauge is equipped with an Auto-Station function that allows
automatic indexing of the station numbers. See page 6–11 for more
information on using this function.
To store readings, take a measurement following the procedure discussed
on pages 4–2 and 4–3. When the density and/or moisture results are
displayed, the reading may be stored.
STORAGE – ASPHALT MODE (AUTO-STATION ENABLED)
Press 〈STORE〉.
If the Auto-Station function is enabled, the display will be:
From the above screen, input the distance from the centerline and press
〈START/ENTER〉 for the display:
Pressing 〈1〉 or 〈2〉 yields:
S ta ti on NUM BE R?
D is ta n ce fr om
center line?
xxx ft.
Left or right
o f ce nte r l in e?
1- LEFT
2- RIGHT
Station: xx
is stored.
Do y ou wa n t to
store more info?