PRINT FUNCTION
The Print function allows stored project data to be downloaded to a printer
or computer. As shown in Figure 5–2, an RS-232 serial port on the gauge
accepts a standard 25-pin “D” type interface cable connector. (To access
the serial port, remove the black cover on the faceplate.) Appendix J
provides instructions on using the HyperTerminal program in Microsoft→
Windows 95→ and later operating systems to print (upload) data to a
computer.
Project data should be downloaded to a printer or computer before erasing.
This provides a permanent record of the data for use later.
Turn gauge and device off. Connect serial interface cable to gauge. Then,
turn both gauge and the serial device on. Press
〈SHIFT〉 and 〈PRINT〉 to
display:
Figure 5–2. Serial Port Location
CAUTION
To prevent damage to the 3440 gauge, turn the gauge
power off before connecting an interface cable.
device
&
Select:
1- one Project
2- all Projects
To Next Page
Loading...
