Troxler 3440 - Page 96

6–16
ENABLE NOMOGRAPH
Press 〈1〉 from the display at the bottom of page 6–15 to enable the
Nomograph function. The display will be:
The gauge will return to the READY display.
DISABLE NOMOGRAPH
To disable the Nomograph function, press 〈2〉 from the display at the
bottom of page
6–15. The display will be:
The gauge will return to the READY display.
CHANGE/VIEW NOMOGRAPH DATA
To change or view the function data, press 〈3〉 from the display at the
bottom of page
6–15. The display will be:
Input the desired overlay thickness. Press 〈START/ENTER〉. The display
is:
The wet density of the underlying or base material may be input using one
of two methods: keypad entry or by using the gauge to record actual
measurements.
Select to set- 1-
Bo tto m d en s.
2-Core dens.
(CE to exit)
NOMOGRAPH
ON
NOMOGRAPH
OFF
Thickness-
x.xx in.
Press ENTER
when completed