Bottom Density – Keypad Entry
From the Select to set– display, press 〈1〉 for:
If the display value is correct, press 〈NO/CE〉.
Press 〈YES〉 if the value is to be changed. The display will be:
Press 〈1〉 to enter data with the keypad. The display will be:
Enter the density of the bottom layer. The next display will be:
density:
x.x
PCF
W
an
t
to
cha
ng
e?
Entering density
1
-
Keypad
2
-
Measure
x
.
x
PCF
Press ENTER
when completed
ON
To Next Page
Loading...
