With the angle of gyration removed, the RAM UP light flashes.
Raise the ram by pressing 〈RAM UP〉.
To manually output data, see page 2-18.
After raising the ram, open the chamber door. Wearing heat-
resistant gloves, remove the mold from the compactor.
Allow the specimen to cool before extruding it from the mold. For
more information on extruding the specimen see page 4-9. After
extruding it from the mold, remove the specimen papers from the
top and bottom of the specimen.
Clean the turntable and the loading head with a degreasing cleaner.
To Next Page
Loading...