✓
Holding the loading head, use a 3/16" Allen wrench to
remove the eight screws and the washers under the screws.
✓
Lift the plate on the ram and thoroughly clean underneath
with a degreasing cleaner.
✓
Thoroughly clean the loading head with a degreasing
cleaner.
✓
Inspect the washer under the plate and the washer inside the
loading head for excessive wear. Replace if necessary.
✓
Using Magnalube-G, generously grease under the plate and
inside the loading head.
✓
Reinstall the loading head. Remember to install the washers.
Finger tighten the screws, then tighten them in a crisscross
pattern with the 3/16" Allen wrench.
✓
Wipe away any excess lubricant with a clean, dry cloth.
✓
Check the tightness of the eight bolts under the upper sliding
plate that connect the plate to the load shaft (part of the ram
assembly).
✓
Check the tightness of the eight bolts under the lower sliding
plate that connect the plate to the upper mold support (part of
the ram assembly).
✓
Following the steps below, clean the thrust bearing and related
parts and grease specified parts (see Figure A-1). During
cleaning, visually inspect all parts for wear. Replace parts if
necessary.
WARNING
To prevent injury, exercise caution when removing or
installing the eight loading head screws.
To Next Page
Loading...
Need help?
General
