32
7.7 CLEANING THE VACUUM UNIT
Each customer uses CS07 at a different frequency. For this reason, there is no specific
instruction on how long a vacuum bag should be utilized.
We recommend you change the bag when the suction power becomes weak, or when the
dust starts attaching to the safety cover.
All the cutting dust will be stored in the vacuum bag
inside the vacuum unit.
Dispose this metal dust following your local
guidelines and regulations.
1. Remove the vacuum bag by pulling it upward.
Be careful not to squeeze the bag as it may make
the metal dust flow outside.
2. Install a new vacuum bag.
Refer to 7.2 Installing the vacuum unit (page 25) for
more details
3. Remove the black sponge from the lid of the
vacuum unit.
Clean the sponge and return it back.
To Next Page
Loading...
Need help?
General
