TRUE SOLTEC CS07 - Trouble Shooting

22
6 TROUBLE SHOOTING
TROUBLE
POSSIBLE CAUSES &
COUNTERMEASUREMENT
OTHER CAUSES &
COUTERMEASUREMENTS
Cutting disc or
grinding wheel stop
working.
⚫ Check the power of CS07
⚫ On LCD operation panel, check if
the cutting/ grinding mode is
activated (Green means activated)
⚫ Press HOME button
⚫ Check if the clamp is placed
correctly. Then, press START
button
⚫ The motor, power supply, or
START button may be
broken.
Please contact us or our local
sales agencies for inspection.
Strange noise
appears.
Remove the cutting disc. Check if there
are any foreign objects get caught.
It is quiet when rotating with no load.
Place the clamp with no terminal on
CS07, press START button and check if
there is any abnormal noise.
Please contact us or our local
sales agencies for inspection.
The cutting wheel is
loose.
Remove the cutting wheel flange and
check if the cutting disc is installed
correctly.
The axis of the motor may have
trouble.
Please contact us or our local
sales agencies for inspection.
The grinding disc is
loose.
-
The grinding part may be
damaged or deformed.
Please contact us or our local
sales agencies for inspection.
Strange smell
appears.
-
Stop using the equipment
immediately.
Please contact us or our local
sales agencies for inspection.
The START button is
broken.
-
Stop using the equipment.
Please contact us or our local
sales agencies for inspection.
The clamp cannot set
on the clamp transfer
unit.
Check if there are any foreign objects on
the clamp transfer unit.
If the transfer unit is rusted/ dirty, use a
sandpaper to clean it.
Check if there are any parts misaligned or
loose.
The clamp may be deformed.
Please contact us or our local
sales agencies for inspection.
The terminal surface
is not clean after
grinding.
Check if there are any foreign protrusions
on the surface of the sandpaper.
Replace the sandpaper.