What to do if cutting disc or grinding wheel stop working on TRUE SOLTEC CS07?
If your TRUE SOLTEC Monitor's cutting disc or grinding wheel stops working, first check the power of CS07. On the LCD operation panel, confirm that the cutting/grinding mode is activated (indicated by a green light). Press the HOME button. Ensure the clamp is correctly placed, and then press the START button.
Why is my TRUE SOLTEC Monitor making a strange noise?
To address a strange noise coming from your TRUE SOLTEC Monitor, first, remove the cutting disc and inspect for any foreign objects that may be caught. Note that the device should be quiet when rotating with no load. Place the clamp with no terminal on CS07, press the START button, and check if the abnormal noise persists.
General| Brand | TRUE SOLTEC |
|---|---|
| Model | CS07 |
| Category | Monitor |
| Language | English |
Explains safety precautions classified as "Warning" and "Caution" for risk assessment.
Visual identification of all included components such as the main unit, camera, lenses, and accessories.
Identifies and describes each numbered component on the front of the CS07 unit.
Details the numbered components located on the rear panel of the CS07 unit.
Explains the main display of the LCD panel, including modes, indicators, and button functions.
Details options for language selection, manual access, and other advanced configurations.
Provides step-by-step instructions on how to properly clamp and secure terminals for cutting.
Explains how to use software and dial to set the precise cutting position for the terminal.
Details the procedure for initiating the cutting process via the LCD operation screen and START button.
Guides the user through the grinding operation, activated when only grinding mode is selected.
Explains how to prepare the clamp and adjust controls to capture cross-section images.
Step-by-step guide for safely removing and installing a new cutting wheel.
Details the process of peeling off old sandpaper and attaching a new one to the grinding disc.
Explains how to clean the internal area of the cutting mechanism using a brush.
Instructs on cleaning the metal debris tray periodically to manage waste from the cutting process.
Identifies optional components like a special clamp and auxiliary lens for big wire cutting.
Provides instructions for connecting and installing the vacuum unit for dust collection.
Details how to attach the 0.5X auxiliary lens to the camera for enhanced magnification.
Guides on correctly clamping and securing large terminals for big wire cutting.
Explains the procedure for cutting big wires, emphasizing vacuum activation.
Details setup and control adjustments for capturing cross-section images of big wires.
Instructs on changing the vacuum bag and cleaning vacuum unit components.
Lists specific optional components required for performing longitudinal cross-section cuts.
Guides on removing the standard cutting wheel and assembling the longitudinal grinding wheel.
Details how to place and secure terminals in the clamp for longitudinal cutting.
Explains the procedure for grinding terminals using longitudinal mode and button controls.
Explains the function of buttons controlling terminal movement during longitudinal grinding.
Details setup and control adjustments for capturing cross-section images of longitudinal cuts.
Lists key specifications for the CS07 unit, covering cutting, grinding, operating conditions, and power.
Presents technical specifications for standard lenses, including magnification, WD, DOF, and FOV.
Outlines technical specifications of the camera, including sensor, resolution, and dimensions.
Shows the physical dimensions of the CS07 unit with numerical labels for height, width, and depth.
Lists contact phone, fax, and email for sales agencies and service inquiries.
Explains the warranty period, coverage limitations, and conditions for repairs.
To Next Page
