44
3.1.2 Sensor
ExitStatus Calibration
Sensor
3.1.2.1 Status
This function is available to check the printer’s sensor status. When enter the [Status]
option, you will see following message.
3.1.2.2 Calibration
This option is used to set the media sensor type and calibrate the selected sensor. We
recommend to calibrate the sensor before printing when changing the media.
Exit
↓↓ ↓
Gap Mode Bline Mode Cont. Mode
↓↓ ↓
Automatic Automatic Automatic
Pre-Printed
↓↓
Manual Manual Manual
↓
↓
Exit
Pre-Printed Exit
↓
Exit
Calibration
Paper Len. 812
Gap Size 24
Intensity 3
Ref. Level 512
To Next Page
Loading...
