TSC TTP-243 Series - Printer Setup; Setting Up the Printer; Loading Label and Tag Stock

8
TTP-243 Bar Code Printer
Service Manua
l

In case of Ticket
The default sensor position is (1) as shown on the figure below. To change to the (2)
position, the customer should notify the manufacturer in advance. There can be only
one position for the sensor. Once the sensor position is agreed upon, it can not be
changed afterwards.
(3) Ribbon End Sensor
The sensor detects the end portion of the ribbon. The ribbon end must be transparent.
(4) Label End Sensor
The sensor detects the end portion of the label.
(5) Peel off Sensor
The sensor detects the backing paper of a label.
(6) Ribbon encoder
The encoder is used to detect if the ribbon is broken.