TSC TTP-345 Programming Manual

TSC AUTO ID Technology Co., Ltd. 6 Copyright 2013 All Rights Reserved.
 AUTODETECT
Description
This command feeds the paper through the gap/black mark sensor in an effort to determine the paper
and gap/black mark sizes, respectively. This command references the user’s approximate
measurements. If the measurements conflict with the actual size, the AUTODETECT command will not
work properly. This calibration method can be applied to the labels with pre-printed logos or texts.
Syntax
AUTODETECT [x,y]
Parameter
Description
x
Paper length (in dots)
y
Gap length (in dots)
Note:
 If the x, y parameters are ignored then the printer will calibrate and determine the paper
length and gap/black mark size automatically.
 When using this command, the printer will detect the label by the proper sensor type so
please don’t set the command GAP or BLINE in your program.
 It is supported in firmware V6.86 EZ or later.
See Also
GAP, SIZE, GAPDETECT, BLINEDETECT

TSC TTP-345 Specifications

General

Brand	TSC
Model	TTP-345
Category	Printer
Language	English