TSC TTP-345 Programming Manual

TSC AUTO ID Technology Co., Ltd. 82 Copyright 2013 All Rights Reserved.
 <ESC>!P
Description
This command is using to PAUSE the printer. The beginning of the command is an ESCAPE character
(ASCII 27).
Syntax
<ESC>!P
Note:
This command has been supported since V6.93 EZ and later firmware.
See Also
<ESC>!O

TSC TTP-345 Specifications

General

Print Method	Thermal Transfer
Resolution	300 dpi
Max Print Speed	5 ips
Max Print Length	90" (2286 mm)
Memory	8 MB Flash
Interface	USB 2.0, RS-232
Power Supply	External universal switching power supply