SELECTING FREQUENCIES
The receiver always selects the VFO mode when it is turned on.
You can select frequen cies using one of the following methods :
Ente r frequencies using the numbered
keypad. Don’t forget to include the
decimal point where applicable.
When you have entered the required
frequency, press the E/VFO key to
accept it. If the frequency you have
entered is not within the selected
frequency step, it is automatically
corrected to the nearest correct
frequency.
e.g. Entering 456.25 followed by
E/VFO results in 456.2500 being
selected.
Direct Frequency Input
1
ENGLISH
18
TSC-3000R
To Next Page
Loading...