TTI TSC-3000R - Full Scan

Th e Fu ll Scan functio n sc ans the entire memorized channel range
for signals.
Notes:
• If a signa l is received , the receiver will remain on the active
channel for the duration of the 'Busy Timer' setting in the
Menu setup. If the 'Busy timer' is set to Busy the receiver will
stay on the active channel for as long as the signal is present.
• To change the bank while searching, briefly press Band/Bank
key.
• To change the scan direction while scanning, rotate the control
knob clockwise or counter clockwise.
• Th e ful l scan fun ction works only within th e Manual Memory
Banks(00 through 39 Banks).
1) Press Func MR to select the
Memory Read mode.
2) Press Bank/Band to select the
preferred memory bank.
3) Set the squelch level to a point
where the receiver is just quiet.
4) Press and hold Scan/Src for 2
seconds. The receiver will begin
scanning the entire full B ands.
2
4
1
Full Scan
1
3
43
TSC-3000R
ENGLISH