TTI TSC-3000R - Automatic Memory Storage and Recall

To store freque ncies into the Automatic Memories:
The Automatic Memory holds frequencies that are stored
automatically while doing a Band Search
1) Press the E/VFO key to select
VFO Mode.
2) Select the band and frequency
that you wish to begin searching
from.
3) Set the squelch level to a point
where the receiver is just quiet.
4) Press Func AW to select the
Automatic Write mode.
5) Pres s the Bank key to sel ect the required memory bank (A0 or
A1).
6) Press the SCAN/SRC key to begin scanning.
7) As active frequencies are fou nd they are automatically stor ed
in the select memory bank. When all 100 channels are fully
stored the receiver will Beep.
8) To exit from the Automatic memory mode, press the E/VFO
key.
Automatic Memories
2 5
6
4
2
1 8
4
4
3
4
35
TSC-3000R
ENGLISH
2