Your scanner receiver is supplied with a rechargeable battery
pack, desktop charging cradle and AC adaptor.
The charging time for a discharged battery is typically 12– 15
hours. When the battery is fully charged, the LED will turn GREEN.
To charge the battery:
1) Fit the battery to the receiver (see instructions above). Ensure
the receiver is switched off.
2) Connect the AC Adaptor to the charging cradle.
3) Plug the AC adaptor into a mains power outlet.
4) Insert the receiver into the charging cradle until it ‘clicks’ home.
The charging LED will glow RED and charging will begin.
• If the charging LED blinks RED and GREEN or does not light
at all, remove the receiver into the cradle and reinsert it.
CHARGING THE BATTERY
ENGLISH
8
TSC-3000R
To Next Page
Loading...