TTI TSC-3000R - VFO Mode

VFO Mode
FUNCTION DESCRIPTION
Busy, 5 Seconds
Busy Timer
VALUES
Determines how long the
receiver will wait on a busy
channel while Scanning or
Searching. When 'Busy' is
selected, the receiver will
stay on the busy channel as
long as it remains busy.
See CTCSS/DCS
Table
Tone
Selects the required CTCSS or
DCS tone. The tone is then
activated or deactivated by
pressing Func TONE.
1 - 10 Seconds
Priority Time
Sets how long the receiver wil
wait before visiting the selected
Priority channel when
Scanning or Searching.
ON, OFF
Beep
Activates or deactivates the
key-press beeps.
0 - 1000
Memory
Shows the available Manual
Memory left in the receiver.
Step
Sets the Frequency Step in
kHz. When Auto is selected the
receiver automatically uses a
factory preset frequency step
for each band.
5, 6.5, 8.33, 9,
10, 12.5, 15, 20,
25, 30, 50, 100,
500, Auto
Delay
Determines how long the radio
will wait on a frequency after a
signal has disappeared while
scanning or Searching.
1 - 10 Seconds
47
TSC-3000R
ENGLISH