5) Press E/VFO when done. [L2] is
displayed.
6) Ent er the Second frequency using
the keypad or the Control knob.
7) Press SCAN SRC. The Limited
Search will begin, searching
upwards from the first frequency
to the second in a continuous
cycle.
8) To stop the Search, press the SCAN SRC ke y ag ain.
• To change the Search direction rotate the Control knob
clockwise or counter clockwise
• The recei ver will stay on an active channel according to the
Scan Timer settings in the VFO Menu. If the Scan Timer is
set to ‘5 seconds’, the receiver will continue Sear ching af ter
5 s econds e ven if the channel i s still busy. If the Scan Timer
is set to ‘Busy’, the receiver will remain on the busy
frequency for as long as it stays busy, then resume
searching when th e signal disappears.
5
7 8
5
6 or
5
6
NOTE: The Limit Search always Searches upwards in Frequency.
If the first frequency is lower than the second it will search between
the two frequencies. If the first frequency is higher then the second
it will search outside the two frequencies.
ENGLISH
26
TSC-3000R
To Next Page
Loading...