To perform a Priority Scan using a stored channel as the Priority
channel:
Notes:
• If a signa l is received , the receiver will remain on the active
channel for the duration of the 'Busy Timer' setting in the
Menu setup. If the 'Busy timer' is set to Busy the receiver will
stay on the active channel for as long as the signal is present.
• To change the channel Bank while searching, briefly press
Band/Bank key.
• To change the search direction while searching, rotate the
control knob clockwise or counter clockwise.
1) Press Func MR to select the
Memory Read mode.
2) Press Bank/Band to select the
required memory bank.
3) Rotat e the C ontrol Knob to select
the required channel.
4) Press Func PRI. The selected
c h a nn e l i s no w th e P r i o r i t y
Channel.
5) Press Band/Bank to select the
preferred channel bank you wish
to scan.
6) Press Scan/Src. The receiver will
begin scanning the selected Bank
and will switch to the Priority
channel at an interval set by the
'Priority Time' setti ng in the setup
menu.
2 5
6
3
1 4
4
1
45
TSC-3000R
ENGLISH
To Next Page
Loading...