Tuttnauer 2540 EHS - Default Chapter; Table of Contents

1
TABLE OF CONTENTS
PARAGRAPH PAGE NO.
1 INTRODUCTION..................................................................................................4
2 SYMBOL DESCRIPTION ....................................................................................4
3 INSTALLATION INSTRUCTIONS .....................................................................5
3.1 Site requirements for installation of a 2540 EHS
....................................... 5
3.2 Site requirements for installation of a 3870 EHS
....................................... 6
3.3 Suggested Site Drain Drawing ..................................................................... 7
3.4 Electrical Specifications ............................................................................... 8
3.5 Placing the Autoclave ................................................................................... 8
3.6 Connections to Utility Supplies .................................................................... 8
3.7 Installation Tests ........................................................................................ 10
3.8 Water Quality .............................................................................................. 11
4 DESCRIPTION OF THE CONTROL SYSTEM. ..............................................12
4.1 System Summary ........................................................................................ 12
4.2 Keyboard ..................................................................................................... 13
4.3 Digital Board DIG - T2 .............................................................................. 13
4.4 Analog Board ANL-T2 ............................................................................... 15
4.5 AC - Board - AC-T1 .................................................................................... 17
5 CALIBRATION OF PRESSURE AND TEMPERATURE ...............................19
5.1 Calibration Overview .................................................................................. 19
5.2 Calibration Theory - Error Compensation: .............................................. 20
5.3 Equipment needed for calibration ............................................................. 20
5.4 Calibration Procedure ................................................................................ 20
6 TESTING AND RESETTING.............................................................................26
6.1 Test Points
................................................................................................... 26
6.2 In – Out Test mode: .................................................................................... 27
6.3 Resetting the Autoclave:
............................................................................. 28
6.4 Input Output Graph: .................................................................................. 29
7 PROPERTIES OF SATURATED STEAM ........................................................35
8 SOFTWARE PROGRAMMING PARAMETERS .............................................36
8.1 General ........................................................................................................ 36
8.2 Changing Parameters ................................................................................. 36
9 MAINTENANCE AND REPLACEMENT PROCEDURES .............................47
9.1 Safety Tests after Repair ............................................................................ 47
9.2 Removing the Autoclave’s Outer Covers ................................................... 48
9.3 Replacing the Safety Valve ......................................................................... 49