37
Installation
⇒
- It is absolutely necessary to remove any salt residues
that may have settled in the tank after rell and before
rinsing.
- After each top-up, start the «Rinse» program. In this
way, any salt grains will dilute and rinse out. Salt res-
idues and the overowing water and salt solution can
cause corrosion if they are not rinsed.
Following the instructions in the start-up paragraph, start
the «Rinse» program.
5.4.4 Automatic regeneration
It is possible to have a water softening device that can com-
pletely regenerate at precise intervals. This process is fully
automatic. Regeneration will be implemented before the se-
lected program is activated.
This device must be preset by the technician during installa-
tion.
Regeneration can also be performed manually, regardless of
the warning message on the display. To start, select the «Re-
generation» program.
To Next Page
Loading...
