Tuttnauer TIVA2 - Starting the Machine; Before Starting the Program

54
Instructions for use - Tiva2 - Tiva2H Thermodisinfector
6.5 Starting the machine
Aftercheckingtheintegrityandfullefciencyofthemachine,
proceed with start-up.
1) Power the machine using the main circuit breaker.
2) Start the machine using the ON-OFF switch (1 Fig. 13) and
open the door (key 5 Fig. 12) to introduce the baskets.
6.5.1 Before starting the program
Before starting each program, check:
- Checkthatthelters,positionedonthebottomofthetank
(Fig. 9) are perfectly clean. Clean them, if necessary.
- The nozzles of the upper and lower spray arms must be free
and clean.
- Basket and products must be arranged correctly.
- The rinse arms must be able to rotate freely. The machine
constantly monitors the rotation speed during the program.
- Liquidcontainersmustbesufcientlylled.Checkforany
messages on the display before starting the program.
Closing the door
- Introduce the basket and load the instruments.
- Close the door and push it until the lock is activated. The door
can be unlocked and opened at any time before the program
starts, by pressing the key (5 Fig. 12).
Selecting the program
To select the programs available, use key 1, 2 or 3 on the
control panel (Fig. 12).
Choose the most suitable program depending on the level of
dirt on the products to be washed.
Program 1 «SHORT» is a washing and disinfection program
fornormaldirt,sufcientfordailyusedinstruments.