Tuttnauer TIVA2 - Starting the Program

55
Using the machine
Program 2 «STANDARD»isaprogramtestedandcertied
according to EN ISO15883withllingoftheadditivedosing
systemfornalorneutralisingrinsing
.
Program 3 «INTENSIVE»isaspecicprogramdesignedfor
treating instruments with stubborn dirt.
6.5.2 Starting the program
WARNING. Always follow the indicated procedures.
Inattentive and supercial use of electrical devices may
lead to risks for the operator.
Tuttnauer Europe b.v. is not liable for possible damage
caused by uncontrolled use of the device.
After selecting the program with relative key, the display shows
the selected program and the operating time and temperature.
To start a program, press the START key (7 Fig. 12).
Program execution
Once the program has started, its progress can be followed
on the display. The display shows the program phases during
operations.
Pre-wash
Pre-wash is carried out with cold water (optional softened water)
and without liquids. It mechanically dissolves encrusted organic
materials and all proteins on the surface of the instruments.
Avoid too high water temperatures.
Wash
It is the actual cleaning cycle. The cleaning tank heats up until
itreachesthespecictemperaturefortheselectedprogram,
a temperature that remains stable for the holding time. The
cleaning liquid is automatically introduced before the start of
the holding time.