Tuttnauer TIVA2 - Programs

52
Instructions for use - Tiva2 - Tiva2H Thermodisinfector
6.4 Programs
The machine leaves the factory programmed with three
separate use programs already entered in the settings
menu.
To select the programs available, use key 1, 2 or 3 (on the
control panel Fig. 12) depending on the most suitable program
for the level of dirt of the load.
The following table shows the correct programs for each type
of load.
Program Use
SHORT Washing and disinfection program for the
Program 1 treatment of instruments with normal dirt, with
times and dosages lower than Program 2.
STANDARD Filling of the dosing system with additive Pro-
gram 2 fornalrinsingorneutralisingafter
 llingorreplacementofthecontainer.
 ProgramtestedandcertiedaccordingtoEN
ISO 15883.
INTENSIVE Washing and disinfection program (not
Program 3 ENISO15883certied)specicforthe
treatment of instruments with stubborn dirt.
Rinse For rinsing water and salt solution of
cold water a particularly dirty load, e.g.: to eliminate
coarse dirt or disinfectant residues
before treatment and to prevent dirt
from drying or the formation of
limescale until a complete program
is started.
Drying Additional drying.