Tuttnauer TIVA2 - Air Suction Filter

74
Instructions for use - Tiva2 - Tiva2H Thermodisinfector
- Check the electrical safety according to VDE 0701/0702.
- Filterinthewaterowvalves.
- Replacetheprelter.
- ReplacetheHEPAlter.
- Check the dosing systems.
- Thermostat sensor, thermoelectric measurements.
- Conditions and functionality of the spray arms.
- Safety thermostat.
- Door gasket.
- Steam condenser.
- The functionality of the drain pump.
- Pressure switch.
- Drain pipes.
- Waterowpipes.
7.1.3 Air suction lter
Thethermodisinfectorisstandardequippedwithasuctionlter
for drying air (Fig. 19), to be replaced after about 100 hours of
work (equal to about 200 cycles).
The machine can also be equipped with an «absolute» «HEPA
H14»classsupplementaryairlter(onrequest),incompliance
with EN 1822.
We recommend replacing the HEP lter every 500 working
hours, which is equivalent to 1000 operating cycles circa.
Fig. 19 - Air suction lter