Chapter 4. Preparing for installation
4.5. Power line connector
The inverter contains a connector for connecting the inverter to an 230 V, 50 Hz electricity network.
The terminals on the connector are marked as follows: L and N. The PE terminal is marked with the earth
symbol .
Fig. 4.1. View of the mains connector
Remember to carry out voltage-free installation work. Otherwise there is a risk of electric shock that
is dangerous to health and life.
Pictures 4.2 - 4.4 below show the subsequent stages of connector preparation. Picture 4.5 shows how to
disconnect the connector.
ps100-26.3en
Power supply wire
To the inverter
Fig. 4.2. Preparing the connector
To Next Page
Loading...
