Fig. 4.5. Unlocking and separating the connector
Note: if you need to disconnect the connector, remember to latch - 1. in Fig. 4.5.
4.6. Installation position
The inverter is designed to be installed vertically on a vertical wall (±15 degree) with connectors facing
downwards. The inverter is not designed to be installed in any others positions, especially:
◦ in horizontal position,
◦ on sloping surface,
◦ when connectors facing downwards,
◦ on the ceiling,
◦ overhangs with its connection sockets facing upwards.
First, fix the mounting plate with 4 screws. Then hang the inverter on this board and secure it with two
screws and an optional padlock.
Fig. 4.6. Wall mounting
To Next Page
Loading...
