SAFETY DECALS
The following safety decals ARE INSTALLED ON THE MACHINE.
If a decal become damaged,illegible or is on the machine,replace it.The decal part number is
listed in the parts lists.
FAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS
INJURY TO THE OPERATOR.
● Do not permit anyone but the operator to
ride on the tractor.
There is no safe place for rider.
● Lock brakes together, use warning lights
and SMV emblem while driving on roads.
● Lower equipment, place gear shift levers
in neutral, stop engine, remove the key
and apply parking brake before leaving
the tractor seat.
● Air pressures are specified by the
manufacturer.
● Before starting and operating
know the operating and safety
instructions in the operators Manual
and on the tractor.
● Clear the area of bystanders.
● Locate and know operation of controls.
● Start engine only from Operator’s
seat with depressed clutch pedal,
transmission in the neutral, PTO
disengaged and hydraulic control in lower
position
● Slow down on turns, rough ground and
slopes to avoid upset.
WARNING
Location: On FENDER RH
Part No.: 1260-904-070-1A
TO AVOID POSSIBLE
PERSONAL INJURY, THIS GUARD MUST
BE KEPT IN PLACE
WARNING
Location: ON PTO guard
Part No.: 1260-904-069-0A
1-11
To Next Page
Loading...
Need help?
General
