typical TW1-571 - On Machines with Typical-Picodrive and Control Unit P44 PD-L

Installation and commissioning
8.09.02
On machines with Typical-PicoDrive and control unit P44 PD-L
● Switch on the machine.
● Call up the parameter input by pressing the "scroll" key.
● To switch the function keys to input (LED in the TE key lights up), press the TE key.
● By pressing the corresponding +/- keys, select parameter "798" and service level C,
see Chapter Selecting the User Level in the separate Control Panel Instruction Manual.
● Select parameter "799" by pressing the corresponding +/- keys.
● Check whether the value on the 571 and 591 is set at "4" and on the 574 at "6" and alter if
necessary.
● Switch the machine off and then on again.
● Select parameter "800" by pressing the corresponding +/- keys.
● Check whether the value is set at "1" (balance wheel turns towards the operator) and alter
if necessary.
● Select parameter "802" by pressing the corresponding +/- keys.
● Check whether the value is set at "0" on the 571 and 591 (= no gear reduction) and at "1"
on the 574 (= gear reduction), alter if necessary.
● By pressing the corresponding +/- key, select parameter "700"
● Sew a stitch by operating the pedal.
● Turn the balance wheel in the sewing direction until the descending needle is level with
the top edge of the needle plate.
● Then check the parameter values listed in the parameter list (see Chapter
10.07 Parameter Settings) and adjust them if necessary.
● Conclude the adjustment of the sewing motor by pressing the TE/Speed key.
30