Read the following content carefully to ensure correct use of the LED display products:
WARNING!
The LED display may be damaged and become irreparable if you ignore the following warnings.
1) Do not place the LED display upside down or throw it during transport and storage.
2) Do not incline, scratch, or crash the LED display during installation.
3) Do not wet or submerge the LED display into water.
4) Do not direct the air outlet of an air conditioner to the LED display.
5) Do not place or use the LED display in an environment with volatile, corrosive or flammable
chemical products.
6) Do not use any electrical accessories not approved by the equipment manufacturer.
7) Make sure the LED display and its auxiliary devices are grounded correctly and reliably before
they are used.
8) Switch off the power immediately and contact the professional personnel when the LED display
has any abnormal conditions such as peculiar smell, smoke, electric leakage, and abnormal
temperature.
9) This equipment should be kept in safe area and inaccessible to children.
CAUTION!
The optimum displaying effect may fail to be achieved if you ignore the following cautions.
1) Wear antistatic gloves when installing or repairing the product.
2) Ensure good ventilation for the LED display when designing the heat dissipation solution.
3) Keep the storage environment of the LED display well ventilated and dry, with a humidity not
exceeding 85%.
4) Use single-phase power supply for an LED display with the total power consumption not
exceeding 3 kW, and three-phase power supply for an LED display with the total power
consumption exceeding 3 kW.
5) Ensure that the LED display is powered on at least twice per week, and at least 2 hours each
time.
6) Installing the LED display in the following places may result in an equipment failure and reduce
its lifespan: near the sea, in an area with salt and alkali or sulphurous gases, near a kitchen
exhaust position, or at a place where the difference between indoor and outdoor temperatures
is great. Consult our professional personnel at the service center if the LED display must be
installed in any of these places.
7) If the product is shipped to Spain, the Spanish manual will be attached accordingly.
8) Low Blue Light Mode
a) Enter the Low Blue Light Mode via Colorlight/Nova software；
b) Low blue light mode can reduce blue light exposure to the eyes, reducing visual fatigue;
c) When using the product, it is recommended to take a 10-minute break every 2 hours;
d) When taking a break, watch the distance and relax;
e) When resting, do eye exercises to relax
To Next Page
Loading...
Need help?
General
