Safety instructions
3.6 Safety instructions
3.6.1 General safety instructions
Only operate the combustion calorimeter when all protective equipment is
present and operational!
Further safety information:
Preceding the corresponding sections!
3.6.2 Information on specific hazards
• After installation, all gas-conveying parts must be checked for proper seal
according to national regulations!
• Observe the national regulations on installation and setup, e.g. IEC/EN 60079-
14!
• All repairs must be carried out by trained specialists, regardless of the type
of work!
3.7 Recurring operator training
Country-specific regulations regarding the recurring instruction of operators
must be observed by the owner, particularly with regard to the handling of
hazardous areas, gases and electrical equipment!
To Next Page
Loading...