6 Transport, installation and acceptance
The combustion calorimeter is generally commissioned by UNION Instruments
GmbH or correspondingly qualified service technicians.
If it is not commissioned by UNION Instruments GmbH (e.g. internal
transport/resale), a suitable procedure must be agreed upon with UNION
Instruments GmbH (
Chapter 13 Service).
6.1 Transport
Tipping over or dropping of the combustion calorimeter from the pallet or load-
carrying means may cause injuries!
Use suitable load-carrying means when unpacking and transporting.
Check slings, if applicable, for adequate load-bearing capacity and sound
condition and fasten them carefully!
Never walk or stand under suspended loads!
If strong shocks occur during transport, these may damage the housing.
Therefore, check the transport container for damage before opening!
In case of transport damage that is indicative of improper handling, a damage
assessment by the transport carrier (rail, mail, shipping company etc.) must be
arranged within seven days.
Ensure before starting or restarting transport that all transport securing devices
are attached.
To Next Page
Loading...