10 Decommissioning/Switching off
Endangerment of people when the combustion calorimeter is decommissioned
by non-instructed personnel!
Endangerment of equipment when the combustion calorimeter is
decommissioned by non-instructed personnel!
To decommission the combustion calorimeter, you must decommission the
linked system components according to their operating instructions as well!
The following table contains steps for decommissioning for extended periods.
To switch off the combustion calorimeter only temporarily, some steps can be
omitted:
Switching off column!
Steps
Set calorimeter to Stop/End measurement, STOP button on control
panel.
X X
Disconnect the device from the process, professionally shut off the gas-
carrying lines.
X X
Bring linked system components to a standstill.
X X
X X
Disconnect voltage supply.
X X
If the combustion calorimeter is to be taken out of service only temporarily, the
process ends here!
Professionally separate/switch off owner-side energy supplies, media supply and
signal transmission.
X
When appropriate, pack the combustion calorimeter in a suitable manner.
Ensure before starting or restarting transport that all transport securing devices are
X
To Next Page
Loading...
